Even with AutoComplete=0 set to the ini file, after accessing the commandline history once, it starts to offer to autocomplete the matching files from the current folder.
Image: https://i.postimg.cc/8cHsQN3V/Auto-Complete-0-Failing-since-tc1100x32.jpg
Bug was found on TC 11.00x32, TC 11.02x32, TC 11.03x32 RC2
This bug does not happens with TC 10.52x32 or older versions.
Steps to reproduce the bug:
---------------------------------------
1. Edit ini file and set AutoComplete=0 at [Configuration] section then start TC.
2. CTRL+DOWN to get the commandline focus.
3. CTRL+DOWN again to get the commandline history. (even if it is empty, does not matter)
4. ESCAPE to close the commandline history.
5. CTRL+DOWN to get again the commandline focus.
6. Press a single key, like the 'A' key, and the Autocomplete popup should show up like shown in the above picture.
Image: https://i.postimg.cc/8cHsQN3V/Auto-Complete-0-Failing-since-tc1100x32.jpg
Bug was found on TC 11.00x32, TC 11.02x32, TC 11.03x32 RC2
This bug does not happens with TC 10.52x32 or older versions.
Steps to reproduce the bug:
---------------------------------------
1. Edit ini file and set AutoComplete=0 at [Configuration] section then start TC.
2. CTRL+DOWN to get the commandline focus.
3. CTRL+DOWN again to get the commandline history. (even if it is empty, does not matter)
4. ESCAPE to close the commandline history.
5. CTRL+DOWN to get again the commandline focus.
6. Press a single key, like the 'A' key, and the Autocomplete popup should show up like shown in the above picture.
Statistics: Posted by byblo — 2024-01-29, 03:26 UTC